VMA Simple Spectrum Analyser – Download page

by

VMA Simple Spectrum Analyser
Download Page

———————————————————–
Important!

When you submit a SYSTEM CODE, please specify which version you want to activate, so that I can generate the correct ACTIVATION CODES.


———————————————————–

For ADF4350, ADF4351 and MAX2870 based devices, please click here:

———————————————————–

For TinySA and TinySA Ultra, please click here:


———————————————————–

For Siglent SSA/SVA Series spectrum analyser, please click here:

———————————————————–

For Rohde & Schwarz CRTU or CMU200 spectrum analyser, please click here:

24 thoughts on “VMA Simple Spectrum Analyser – Download page”

  4. Hello.
    You need to run the software, generate a SYSTEM CODE based on the MAC Address of a physical network device (do not use a virtual network device) and send it to me: v m a AT n o r c a m DOT p t.
    The instructions are visible on the download page and in the user manual, as well. I think my email is shown inside the software, too!

    Kind regards,
    Vitor

    Reply

  5. I have installed you VMA Simple Spectrum Analyser for ADF4351 on windows 7. I have taken the activation code from you and now the GUI is visible to me but soon I push the START button the hole GUI hang and there is no output on the screen.

    please help

    Reply

  7. You need to select your device in the SETUP tab. If you have a D6 or a LTDZ you need to explicitly select it, otherwise the software will hang. These devices are not 100% compatible with the SMA/NWT by BG7TBL!

    Reply

  9. Fantastic software, I'm really pleased as it is so easy to use. I was ready to bin my cheap 4.4ghz spectrum analyser as the software that came with it didn't work. Now I can use it to get my QO-100 uplink going on a budget.
    Thankyou for writing this, I will be recommending your software to all my radio amateur friends as several of us have these devices….

    Reply

  13. i had been using my LTDZ_35-4400M_Spectrum with the software and i paused for a bit , i had a permanent code, now i've restarted with the same device and key and the software just doesnt work at all, it ask if to remove code, says it cant find the device with MAC, but the NWT software works , can anyone assist with any suggestions. i am using the latest software

    Reply

  15. Hi, I would like to use LTDZ_35-4400M Spectrum Analyzer board for my special project. Question is if exist some info about communication protocol on USB (serial port). Can I find some document with info about this communication? Thank you Jiri

    Reply

  16. You can read all specs of the communication protocol in the last chapter of the WinNWT or LinNWT user manual.
    I cannot provide you this document, because I don't own the intellectual property.
    However, a good Google search should help you.

    Reply

  22. Hi. No you don't. Just send me an email with the request. One donation entitled you for as many permanent codes as you need. Regards, Vitor

    Reply

  23. Good day VMA. I would like an activation code for RF Spectrum analuzer (with tracking generator) based on ADF4351 (35Mhz-4400Mhz), this one with the side SMA connectors. Could you please send me an e-mail while you can? Thanks. 🙂

    Reply

  24. Hello,
    I don't know your email! Also, you need to download and start the software to generate the SYSTEM CODE, which you need to send to me.
    Please take your time to read the information and the user manual.
    Kind regards,
    Vitor

    Reply

Leave a Comment